The act of hot wiring is not difficult, but many people would prefer not to do it because it can be loud and messy. The best way to get a motorcycle running without the use of keys is by pulling out the headlight bulb in the front, then taking off the air filter in the back. Next you need to find two wires that are each in their own spot, one black and one white. Take off the black wire casing and twist them together.
Is it easy to hotwire a motorcycle?
A bike can be hotwired by bypassing the ignition switch and attaching wire cables to the battery and grounding them. There is also an alternate method for taking control of a bike, which requires you to cut off the key cylinder and push in pins on the side of it with a screwdriver until they come out.
How to hotwire a motorcycle?
The term hotwire refers to the process of bypassing a vehicle’s electric-starter system by running a wire from the battery directly to the starter. Hotwiring a motorcycle is a difficult task for those without experience or knowledge in electric circuitry. However, it can be done with some basic tools and some quick thinking.
Tools you need:
You’ll need: 2 screwdrivers, A Phillips head and flathead, A cut-off wheel, A drill bit, Wire strippers, Flux core solder.
The first step to hotwiring a motorcycle is to locate the battery. Most motorcycles have their battery located under the seat. Next, take off the seat and disconnect the black wire that connects to the negative terminal of the battery. Once you have done this, take off any plastic caps that are on top of the posts on the other side of the battery. Next, find your positive wire and loosen it by turning it counterclockwise with a wrench or pliers.
More experienced hotwiring enthusiasts will have a preferred technique that they use regularly. First, it is best to disconnect the battery from the vehicle. Tap the battery with a hammer or similar blunt instrument, and then reattach it. You can now remove the negative terminal from the battery. Take a look at the circuit diagram below, and attempt to identify the circuit you are working with.
You can now attempt to remove the fuse, if there is one. If there isn’t a fuse, you can proceed to the next step. Next, remove the negative terminal from the vehicle. The negative terminal is usually located on the vehicle’s frame, or it may be located inside the vehicle, and will be accessible by removing the hood. Remove the negative terminal from the vehicle.
If you are not sure what the circuit is, you can now identify the positive terminal on the battery. The positive terminal is usually located on the battery, and will be accessible by removing the battery. Remove the positive terminal from the vehicle.
If you are now sure of what is on the circuit, you can proceed to test the circuit.
First, you can now turn on the ignition switch. If the positive terminal is on the vehicle, it will be energized. If the battery is energized, the positive terminal will be energized. If the positive terminal is not on the vehicle, the battery will not be energized. Next, you can test the circuit.
Conclusion
Your motorcycle won’t start? You’re out of gas? No matter what the reason, you can’t get your motorcycle running. This article will show you how to hotwire your motorcycle so it can run without gas.
Tags: hotwire
Leave a Reply